Troubleshooting - Drill Master 66965 Set Up And Operating Instructions Manual

problem
Tool will not start.
Performance
decreases over time.
Excessive noise or
rattling.
Overheating.
Follow all safety precautions whenever diagnosing or servicing the
tool. Disconnect power supply before service.
pLEaSE REaD thE FOLLOWIng CaREFuLLY
THE MANUfACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND ASSEMBLy DIAgRAM
IN THIS MANUAL AS A REfERENCE TOOL ONLy. NEITHER THE MANUfACTURER OR DISTRIBUTOR MAkES
ANy REPRESENTATION OR WARRANTy Of ANy kIND TO THE BUyER THAT HE OR SHE IS qUALIfIED TO
MAkE ANy REPAIRS TO THE PRODUCT, OR THAT HE OR SHE IS qUALIfIED TO REPLACE ANy PARTS
Of THE PRODUCT. IN fACT, THE MANUfACTURER AND/OR DISTRIBUTOR ExPRESSLy STATES THAT
ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE UNDERTAkEN By CERTIfIED AND LICENSED
TECHNICIANS, AND NOT By THE BUyER. THE BUyER ASSUMES ALL RISk AND LIABILITy ARISINg OUT
Of HIS OR HER REPAIRS TO THE ORIgINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISINg
OUT Of HIS OR HER INSTALLATION Of REPLACEMENT PARTS THERETO.
Page 12

troubleshooting

possible Causes
1. No power at outlet during
charging.
2. Internal damage or wear.
(Carbon brushes or switch, for
example.)
1. Accessory dull or damaged.
2. Carbon brushes worn or
damaged.
Internal damage or wear. (Carbon
brushes or bearings, for example.)
1. Forcing tool to work too fast.
2. Accessory misaligned.
3. Accessory dull or damaged.
4. Blocked motor housing vents.
For technical questions, please call 1-800-444-3353.
Likely Solutions
1. Check power at outlet. If outlet is
unpowered, turn off tool and check circuit
breaker. If breaker is tripped, make sure
circuit is right capacity for tool and circuit
has no other loads.
2. Have technician service tool.
1. Keep accessories sharp. Replace as
needed.
Have qualified technician replace
2.
brushes.
Have technician service tool.
1. Allow tool to work at its own rate.
2. Check and correct accessory to fence
and/or table alignment.
3. Keep cutting accessories sharp.
Replace as needed.
4. Wear ANSI-approved safety goggles and
NIOSH-approved dust mask/respirator
while blowing dust out of motor using
compressed air.
SKU 66965