General Operating Instructions - Drill Master 66965 Set Up And Operating Instructions Manual

tO pREVEnt SERIOuS InjuRY:
Do not adjust or tamper with any
control or components in a way
not specifically explained within
manual. Improper adjustment
can result in tool failure or other
serious hazards.
Charging
Battery Pack (11)
Cord
Battery Charger (20)
1. Place the Battery Pack (11) on a dry
fireproof surface in a room where the
temperature is from 50–104° F.
note: If recharging a newly spent Battery
Pack, allow it to cool completely before
charging.
Make sure the Battery pack is
undamaged; do not charge a cracked
or leaking battery pack.
2. Disconnect the Cord from the Battery
Charger (20). Attach the Adapter plug to
a grounded, 120 V~, 60 Hz outlet.
3. Insert the Battery Pack into the Charging
Socket of the Battery Charger, observing
the polarity.
4. Attach the Adapter (21) Cord to the
Battery Charger.
5. The charging indicator light on the
Battery Charger will illuminate to show
that charging is taking place.
Page 8
Adapter (21)
Figure 2
For technical questions, please call 1-800-444-3353.
note: The Battery Charger will not
automatically turn off when the Battery
is fully charged, and the charging
indicator light will remain on until the
Battery Charger is disconnected from the
electrical outlet. Recharging the Battery
Pack for more than 7 hours can cause
damage to the battery cells.
6. The initial charge time is 7 hours. For a
fully discharged battery, allow the Battery
Pack to Charge for at least 5 hours. Do
not charge the Battery pack longer
than 7 hours.
7. Unplug the Charger and disconnect it
from the Battery Pack when finished.
8. While charging, the Battery Pack and
Charger, and Adapter may become warm
to the touch. This is normal, and does
not indicate a problem.
9. Allow the Battery Pack to cool completely
before using it.
10. Store the Charger and Battery Pack
indoors, out of reach of children.
WaRnIng! Do NOT use a different
Charger or Battery to power this Drill.

general Operating Instructions

FROM aCCIDEntaL
OpERatIOn: always make sure
the trigger Switch of the
Cordless drill is in its "OFF"
position, the Battery pack is
removed from the Drill, and the
Direction Selector (13) is
centered in its mid-position
(which locks the trigger) prior to
making any adjustments to the
tool.
tO pREVEnt
SERIOuS InjuRY
SKU 66965