Troubleshooting - Drill Master 69652 Owner's Manual & Safety Instructions

troubleshooting

problem possible Causes
Tool will not start. 1. Battery Pack not properly
connected.
2. Battery Pack not properly charged.
3. Battery Pack burnt-out.
4. Internal damage or wear.
Tool operates 1. Forcing tool to work too fast.
slowly.
2. Battery Pack power low.
3. Battery Pack burnt-out.
Performance 1. Accessory dull or damaged.
decreases
2. Battery Pack wearing out.
over time.
Excessive noise Internal damage or wear. (Carbon
or rattling. brushes or bearings, for example.)
Overheating. 1. Forcing tool to work too fast.
2. Accessory dull or damaged.
3. Blocked motor housing vents.
Follow all safety precautions whenever diagnosing or servicing the tool.
Disconnect Battery pack and Charger power supply before service.
Item 69652
1. Remove Battery Pack, make sure there are no obstructions,
reinsert the Battery Pack according to its shape (it should only fit
one way), and press firmly until the Battery Pack locks in place.
2. Make sure Charger is connected and operating properly.
Give enough time for Battery Pack to recharge properly.
3. Dispose of old Battery Pack properly or recycle.
Replace Battery Pack.
4. Have technician service tool.
1. Allow tool to work at its own rate.
2. Recharge Battery Pack.
3. Dispose of old Battery Pack properly or recycle.
Replace Battery Pack.
1. Keep cutting accessories sharp. Replace as needed.
2. Battery Pack capacity will gradually decrease through use.
If symptoms are severe, recycle old Battery Pack
(or dispose of properly) and replace it.
Have technician service tool.
1. Allow tool to work at its own rate.
2. Keep cutting accessories sharp. Replace as needed.
3. Wear ANSI-approved safety goggles and
NIOSH-approved dust mask/respirator while blowing
dust out of motor using compressed air.
For technical questions, please call 1-800-444-3353.
likely Solutions
Page 11