Table of Contents
Advertisement
10.
Note: Ni-Cd BATTERY MUST BE
RECYCLED OR DISPOSED OF
PROPERLY. Do not short, incinerate
or open Battery Pack.
maIntEnanCE anD
SERVICIng
Procedures not specifically
explained in this manual
must be performed only by a
qualified technician.
FROm aCCIDEntaL
OpERatIOn: turn off tool and
remove Battery before
performing any inspection,
maintenance, or cleaning
procedures.
problem
Tool will not start.
Hammer function not
available.
Performance
decreases over time.
Excessive noise or
rattling.
Overheating.
Follow all safety precautions whenever diagnosing or servicing the
tool. Disconnect power supply before service.
SKU 67024
tO pREVEnt
SERIOuS InjuRY
troubleshooting
possible Causes
Battery not charged.
Selector Ring in drilling position. Slide Selector Ring into hammering position.
Accessory dull or damaged.
Internal damage or wear.
1.
Forcing tool to work too fast.
2.
Accessory dull or damaged.
3.
Blocked motor housing vents.
For technical questions, please call 1-800-444-3353.
tO pREVEnt SERIOuS
InjuRY FROm tOOL
FaILuRE: Do not use
damaged equipment. If
abnormal noise or vibration
occurs, have the problem
corrected before further use.
Cleaning, maintenance, and
Lubrication
1.
BEFORE EaCH uSE,
general condition of the tool. Check
for loose hardware, misalignment or
binding of moving parts, cracked or
broken parts, damaged electrical wir-
ing, and any other condition that may
affect its safe operation.
2.
aFtER uSE,
of the tool with clean cloth.
3.
When storing, always store Impact
Wrench in clean, dry and safe loca-
tion out of reach of children.
Likely Solutions
Charge Battery.
Keep accessories sharp. Replace as needed.
Have technician service tool.
1.
Allow tool to work at its own rate.
2.
Keep cutting accessories sharp. Replace
as needed.
3.
Wear ANSI-approved safety goggles and
NIOSH-approved dust mask/respirator while
blowing dust out of motor using compressed
air.
inspect the
wipe external surfaces
Page 9
Hide quick links:
Advertisement
Table of Contents
