Main Menu; System Time; System Date; Legacy Diskette A - Asus M3A78-CM User Manual

2.3

Main menu

When you enter the BIOS Setup program, the Main menu screen appears, giving you an
overview of the basic system information.
Refer to section "2.2.1 BIOS menu screen" for information on the menu screen items and
how to navigate through them.
Main Advanced
System Time [19:34:30]

System Date

Legacy Diskette A

Primary IDE Master
Primary IDE Slave
SATA1
SATA2
SATA3
SATA4
SATA5
SATA6
SATA Configuration
System Information
v02.61 (C)Copyright 1985-2008, American Megatrends, Inc.
2.3.1 System Time [xx:xx:xx]
Allows you to set the system time.
2.3.2 System Date [Day xx/xx/xxxx]
Allows you to set the system date.
2.3.3 Legacy Diskette A [1.44M, 3.5 in.]
Sets the type of floppy drive installed. Configuration options: [Disabled]
[360K, 5.25 in.] [1.2M , 5.25 in.] [720K , 3.5 in.] [1.44M, 3.5 in.] [2.88M, 3.5 in.]
2.3.4

Primary IDE Master/Slave and SATA 1~6

While entering Setup, the BIOS automatically detects the presence of IDE/SATA devices.
There is a separate submenu for each IDE/SATA device. Select a device item then press
<Enter> to display the IDE/SATA device information.
The BIOS automatically detects the values opposite the dimmed items (Device, Vendor, Size,
LBA Mode, Block Mode, PIO Mode, Async DMA, Ultra DMA, and SMART monitoring). These
values are not user-configurable. These items show Not Detected if no IDE/SATA device is
installed in the system.
Chapter 2: BIOS setup
BIOS SETUP UTILITY
Power Boot Tools
[Wed 08/27/2008]
[1.44M, 3.5 in.]
:[Not Detected]
:[Not Detected]
:[Not Detected]
:[Not Detected]
:[Not Detected]
:[Not Detected]
:[Not Detected]
:[Not Detected]
:[Not Detected]
Exit
Use [ENTER], [TAB]
Use [ENTER], [TAB]
or [SHIFT-TAB] to
or [SHIFT-TAB] to
select a field.
select a field.
Use [+] or [-] to
Use [+] or [-] to
configure system Time.
configure system Time.
Select Screen
Select Item
Select Screen
+-
Change Field
Select Item
Tab Select Field
+-
Change Field
F1 General Help
Tab Select Field
F10 Save and Exit
F1 General Help
ESC Exit
F10 Save and Exit
ESC Exit
2-9