Realignment; How To Enter Each Mode; Self Programing Mode - Kenwood TK-768 Service Manual

1. Modes
DATA PROGRAMMING MODE
PC TUNING MODE
TK.76BIH
REALIGNMENT
I
Conventional mode/Trunking (SmarTrunk) mode
Switch between Conventional mode and Trunking mode by holding
down the tMONll key in POWER ON.
This can be selected when installed with a board with the trunking
mode function (board model ST-865KW2).
Note : The SmarTrunk IIrM call is a registered trade-
mark of the Selectone Corporation.
)
I
3. Self Programing Mode
3-1. Setting the channels
The dealer can set the functions, such as frequency
and signaling, for each channel of the transceiver with-
out using the FPU.
Operation
1. Hold down the IAI key and turn the power on, and
keep the [Al key pressed for two seconds to enter
the initial mode. The display changes from "PrOG"
t o " S E L " .
2. When the [MON] key is pressed again, the channel
set mode is entered. The display shows "CH1".
3. There are channels 1 to 32. Then [D/A] key incre-
ments the channel number, and the [SCN] key dec-
rements the channel number.
4. The setting items are listed in Table 1. When the
choice is changed and the ICHVI key is pressed, the
displayed value for the current item is stored in
memory and the next item appears.
5. When the [MON] key is pressed, the initial mode
"SEL" returns.
Mode Function
USER MODE Customer use this mode.
CONVENTIONAL MODE This mode is for use as a trans-
ceiver.
TRUNING (SmarTrunk)
MODE
This mode used when a trunking
board has been installed.
DEALER MODE
This mode is used bv the dealer
for making settings Íor the modes.
PANEL TEST MODE Dealer uses to check the funda-
mental characteristics.
P A N E L T U N I N G M O D E Dealer uses to tune the radio.
PC MODE
This mode is communication the
radio to PC (lBM compatible).
It requires the KPG-29D.
DATA PROGRAMMING MODE
This mode is Írequency data and
features write to the radio and
read from the radio.
This feature is include the FPU.
PC TEST MODE
This mode can check the radio by
PC control. This feature is include
the FPU. This paragraph is as
same as PANEL TUNING.
2. How To Enter Each Mode
Mode Operation
USER MODE
Usually Power ON then begin this mode.
DEALER MODE
The A switch is held on with Power ON the radio. The A switch holdinq about 2 sec. after Power ON the radio.
PANEL TEST MODE The D/A switch is held on with Power ON the radio. The D/A switch holding about 2 sec. aÍter Power ON the
radio. But, if this mode is disabled by FPU then begin the USER MODE.
P A N E L T U N I N G M O D E
The SCAN switch is held on with Power ON the radio. The SCAN switch holdings about 2 sec. after Power ON
the radio. But, if this mode is disabled by FPU then begin the USER MODE.
PC MODE
The radio Power ON to begin the USER MODE when through to the microphone then begin this mode.
Note : PANEL TEST MODE and PANEL TUNING MODE does not beoin the PC MODE.