HP 3000 9x9KS Service Manual page 100

The two original halt codes are B000 (for Monitor Halt) and B007 (for System Abort). In the following
numbers displayed portion, N in Figure 4-1, is a sequence number, so that all informational numbers in a
sequence can be added together to obtain the number equaling definition for the halt. Those number are
found in Tables 4-14 and 4-15.
Code
0001 to 0019
0020
0021
0022
0028
0029
0030
0031
003E
003F
0040
0041
4-16 Display Codes
Figure 4-1. MPE/ix Code Display Description
Table 4-15. MPE/iX B000 Halt Codes
Description
The breaker handler to remote data base was re-entered
A breaker 0 instruction was encountered without R
An unknown HPMC occurred
A non recoverable LPMC occurred
Reinitialize IODC failed to read entry init
Reinitialize IODC failed to read entry I/O
Image larger than first memory controller
Series 800 processor will not function in a Series 900 system
A non recoverable branch taken or break trap occurred
A bad instruction received from remote data base
A configured module was lost on power fail
A bus converter was lost on power fail