3. INStaLLING tHE BELt coVEr aND tHE BoBBIN WINDEr
WarNING :
to protect against possible personal injury due to abrupt start of the machine, be sure to start the
following work after turning the power off and ascertaining that the motor is at rest.
4. aDJuStING tHE HEIGHt oF tHE KNEE LIFtEr
WarNING :
to protect against possible personal injury due to abrupt start of the machine, be sure to start the
following work after turning the power off and ascertaining that the motor is at rest.
1) The standard height of the presser foot lifted using the knee lifter is 10 mm.
2) You can adjust the presser foot lft up to 3 mm usng knee lfter adjust screw 1 . (Max. 9 mm for A type)
3) When you have adjusted the presser foot lift to over 10 mm, be sure that the bottom end of needle bar
2 n ts lowest poston does not ht presser foot 3 .
(mm)
47
63.5
75.5
1
– 2 –
(DDL-8700L)
3
(mm)
63.5
75.5
2