Reset; Download Setup; Downloading The Software; Information - Sharp LC-60LE925X Operation Manual

Appendix

Reset

If complex adjustments are made and the settings
cannot be restored to normal, you can reset the
settings to the factory preset values.
Press MENU and the MENU screen displays.
1
Press c/d to select "Setup".
2
Press b/c/d to select "View setting".
3
Press a / b to select "Reset", and then press
4
ENTER.
If you have already set the password, enter it
5
here.
• "Return to factory pre-settings" displays on the
screen.
Press c / d to select "Yes", and then press
6
ENTER.
• "Now, TV will restart automatically. OK?" displays
on the screen.
Press c / d to select "Yes", and then press
7
ENTER.
• "Now initialising..." displays on the screen and
blinks.
• After the reset has completed, the power shuts
off and then comes back on. The screen will have
returned to its original settings.
Press a / b to select the desired language
8
listed on the screen, and then press ENTER.
Press c / d to select "HOME" or "STORE",
and then press ENTER.
Setting the country.
9
Press a / b to select your country or area, and
then press ENTER.
• This setting screen only appears during the initial auto
installation.
Press c/d to select "Digital Search" or
10
"Analogue Search", and then press ENTER.
• When the country setting is set to "Australia", only "Digital
Search" is available.
The TV searches for, sort and stores all the
11
receivable TV stations according to their
settings and the connected antenna.
• To abort the initial auto installation in progress, press
RETURN.
NOTE
• When the TV is in "STORE" mode, repeat steps 1 to 8 to change to
"HOME" mode.
• "Reset" is greyed out in 3D mode. To select the "Reset" menu, you
need to switch to 2D mode.
82
After factory presetting,
TV will restart automatically
Now initialising...

Download setup

The TV automatically determines whether a new software
version is available when the TV is in standby mode.
Go to "Menu" s "Setup" s "View setting" s "Individual
setting" s "Standby search" s "Download setup".
Selected item
Automatically searches for new software
Yes updates available when the TV is in
standby mode.
Does not search for update information.
No
Checks if there is new software
Now
immediately.

Downloading the software

You can select the method of update.
If the software is updated, the confi rmation
1
message "New download information has
been detected." appears.
• If the TV receives the update service while in
standby mode, a confi rmation message displays
after turning on the power.
Follow the screen prompts.
2
Selected item
Starts downloading immediately.
Typically, it takes approximately 30
minutes for download. You cannot carry
out other operations while downloading.
Yes
• Cancels the download by pressing
ENTER on the remote control unit when
"Discontinue" is displayed on the screen
during the update.
Starts downloading automatically several
No
minutes after entering standby mode.
NOTE
• Updating the software may take several hours in the worst case.

Information

Message list

When a new broadcast station is detected, the message is
updated in the "Message list" of the "Information" menu.
NOTE
• If there are unread messages in the "Message list", "New
information" is displayed on "Channel display". (See page 21.)

Receiver report

Display reports regarding failures and changes for timer
settings.
Identifi cation
You can check the current version of the software on the
screen.
Description
Description