Volvo 2015 S60 Owner's Manual page 332

08 Wheels and tires
Changing a wheel
Jack attachment points
7. There are two jack attachment points on
each side of the vehicle. Position the jack
correctly in the attachment (see the illus-
tration) and crank while simultaneously
guiding the base of the jack to the
ground. The base of the jack must be flat
on a level, firm, non-slippery surface.
Before raising the vehicle, check that the
jack is still correctly positioned in the
attachment.
8. Raise the vehicle until the wheel to be
changed is lifted off the ground.
9. Unscrew the wheel nuts completely and
remove the wheel.
08
330
WARNING
•
The jack must correctly engage the
jack attachment.
•
Be sure the jack is on a firm, level,
non-slippery surface.
•
Never allow any part of your body to
be extended under a vehicle suppor-
ted by a jack.
•
Use the jack intended for the vehicle
when changing a tire. For any other
job, use stands to support the vehicle.
•
Apply the parking brake and put the
gear selector in the Park (P) position.
•
Block the wheels standing on the
ground, use rigid wooden blocks or
large stones.
•
The jack should be kept well-greased
and clean, and should not be dam-
aged.
•
No objects should be placed between
the base of jack and the ground, or
between the jack and the attachment
bar on the vehicle.
NOTE
The jack provided with your vehicle is
intended to be used only in temporary sit-
uations such as changing wheels in the
event of a flat tire. Only the jack that came
with your particular model should be used
to lift the vehicle. If the vehicle needs to be
lifted more frequently or for a prolonged
period, using a garage jack or hoist is rec-
ommended. Always follow this device's
instructions for use.
Re-installing the wheel
1. Clean the contact surfaces on the wheel
and hub.
2. Lift the wheel and place it on the hub.
Tighten the wheel nuts