Volvo 2015 S60 Owner's Manual page 174

04 Driver support
City Safety™
Cause
The area of the wind-
shield in front of the sen-
sor is dirty or covered by
ice or snow.
The laser sensor's field
of view is obstructed.
04
172
CAUTION
Action
If a crack, scratch or stone chip should
Clean the
occur in the section of the windshield in
windshield or
front the laser sensor, contact a trained
remove the ice/
and qualified Volvo service technician to
snow.
repair or replace the windshield (see the
illustration showing the location of the sen-
Remove the
sor on page 170). Failing to do so may
obstruction.
result in reduced City Safety™ functional-
ity.
To help prevent limited or reduced func-
tionality, please also observe the following:
•
Volvo recommends that cracks,
scratches or stone chips on the wind-
shield in front of the laser sensor
should not be repaired; in such cases,
the entire windshield should be
replaced.
•
Before the windshield is replaced,
contact a Volvo retailer to ensure that
the correct windshield is ordered and
installed. If the wrong type of wind-
shield is used, this may cause City
Safety™ to function improperly or not
at all. Volvo recommends the use of
only Genuine Volvo Replacement
Windshields.
•
When replacing windshield wipers, use
the same type or ones approved by
Volvo.
The laser sensor
The upper decal describes the laser beam's
classification and contains the following text:
Invisible Laser radiation – Do not view directly
with optical instruments (magnifiers) – Class
1M laser product.
The lower decal describes the laser beam's
physical data and contains the text:
IEC 60825-1:1993 + A2:2001. Complies with
FDA performance standards for laser prod-
ucts except for deviations pursuant to Laser
Notice No. 50, dated July 26th, 2001
The laser beam's physical data is listed in the
following table: