Table of Contents
Advertisement
25XX-100, -110
Roller, lower pinch removal
1. Remove the top cover. Go to
page
4-8.
2. Slide the carrier to the far left of the printer.
3. Remove the four screws (A) from the paper feed motor bracket.
4. Remove the screw from the top of the serial interface card
bracket.
5. Disconnect the paper feed motor cable from the logic board,
and then remove the paper feed motor and bracket from the
printer.
6. Slide the carrier to the left side of the printer.
"Covers, top removal" on
B
B
Repair information
4-39
Advertisement
Table of Contents
