Panel Dimensions - Dometic RM 2620 Installation And Operating Instructions Manual

Classic series refrigerator for lp-gas and electric operation

Hide thumbs

Table Of Contents

Table of Contents

Enlarged version

INSTRUCTIONS FOR MOUNTING

THE DOOR PANEL

The refrigerator is normally delivered without door pan-

els. Before starting the mounting work, check that the

panel dimensions are in compliance with those given in

the table and the instructions are read thoroughly.

When mounting the panel, proceed as follows):

A. On new refrigerators, the decoration strips are taped

inside the door; if installed on the door, remove the

door decoration strip (2) by removing its two screw

(1).

B. Insert one vertical edge into the groove of the door

frame (3).

C. Bend the panel gently so that the free side of the

panel can be slipped into the corresponding groove

of the door frame (4). Slide the panel down into the

groove of the bottom frame (5).

D. Between the upper edge of the panel and the door

frame there is a gap which should be covered by the

decoration strip.

E. Put the decoration strip across the door so that the

gap is covered and push it upward (6). The tabs on

the inside of the strip should fit behind the flange of

the door frame. Secure the decoration strip with the

two screws removed in Step A (1).