Dometic RM 2620 Installation And Operating Instructions Manual page 13

H. LP gas pressure low at burner.
Set main regulator so pressure does not drop below
11 inches water column at pressure tap.
I. Burner not located properly under flue tube.
Relocate.
J. Burner damaged.
Replace.
K. Odors from fumes.
1. Dislocated burner.
2. Damaged burner.
3. Dirty flue tube.
L. FUSES
1. Refrigerator AC Supply.
2. Control system. See page 11, part Fuses.
NOTE: AVOID SPRAYING WATER THROUGH THE
REFRIGERATOR VENTS WHILE WASHING YOUR RV.
All the above instructions are to be followed closely. The
refrigerator is quality-guaranteed. However, we are not
responsible for any failures caused by improper adjust-
ments and unfavorable installation conditions. Contact
service point or distributor service dept. for assistance.
CHANGING DOOR HINGES FROM
ONE SIDE TO THE OTHER
Open the top door and remove the two screws holding
the top decoration. The screws are accessible from
beneath. (See FIG. 12)
Remove the top hinge pin and lift out the top door.
Remove center hinge pin and lift out the lower door.
Unscrew the bottom hinge pin. Remove the plastic cap
from the opposite lower hinge and place it in the hole
just "left empty" by the lower hinge pin. Screw the lower
hinge pin in the hole from which the plastic cap was
removed.
Before replacing the doors on the refrigerator, remove
the catches and move them to the opposite side of the
cabinet. The screw holes are covered with plastic caps
that must be removed and inserted in the screw holes
that previously held the catches. NOTE: The plastic caps
are not installed on new refrigerators and are in the parts
bag.
Remount the doors and hinge pins in the reverse order
of their removal. Unscrew the handles and re-fasten
them on the opposite side of the door. Insert the plastic
caps (from the parts bag) into the holes left open on the
doors. Check the door gaskets. If they are correct, then
replace the top decoration.
FIG. 12
13