Table of Contents
Advertisement
APPENDIX 2 MESSAGES
8. "Checking"
Checking MIME.
9. "Now decoding..."
10. "Completed."
Save/MIME completed.
11. "Decode failed."
MIME decoding failed.
12. "This terminal does not support this code."
You attempted to decode a file not supported by the terminal.
13. "Decoded % file(s)."
Decoding MIME-coded file.
14. "This file is not encoding."
You selected a file that has not been coded.
15. "Directory not found."
You specified a folder that does not exist.
F3: Transmit
1. "Input Error: Message File."
Invalid message selected for transmission.
2. "Input Error: Country/Ocean Code."
Invalid country/ocean code entered.
3. "Input Error: Destination."
Invalid station ID entered.
4. "Input Error: Modem Type."
Invalid mode type entered. (For FAX, select T30.)
5. "Input Error: E-Mail Address."
Invalid e-mail address entered.
6. "Input Error: LES ID."
Invalid LES ID entered.
7. "Input Error: Send Delay."
Invalid send delay time entered.
8. "Input Error: Prefix Code."
Invalid prefix code entered.
9. "Invalid character detected in message."
Invalid character found in TX message.
10. "Don't support E-Mail service in this NCS."
Selected NCS does not handle e-mail.
11. "Input Error: Too many stations."
You have selected too many stations to transmit to.
12. "Message file is too large (but enable to send)."
The size of the file you want to send is larger than 32,000 bytes. (The file can be sent, but only the
first 32,000 bytes of information will be received.)
13. "Attach file is too large."
The size of the attachment you want to send is larger than 32,000 bytes.
14. "Attach file (file name) is not found."
Cannot find attached file.
15. "Message is entered in sending Queue. Press any key."
TX message entered into queue.
16. "Can't enter this message to sending Queue. Press any key."
Could not enter TX message into queue.
AP-10
Advertisement
Table of Contents
