Sleep Function (Ac Operation Only); System Reset - Logik L55DAB10 Instruction Manual

Sleep Function (AC Operation Only)

This function allows you to program the unit to switch off by itself after a set period of time.
1. To activate the sleep function, press the SLEEP button repeatedly until the "Sleep Timer"
shows on the display. The time will change in the below sequence on every press:
2. When your desired sleep time appears in the display, release the button and the sleep
function will be activated in two seconds. "S#" will show on the display (for example "S1"
represents "10 minutes" sleep time).
3. When the sleep time counts to zero, the unit will go off. To put the sleep function off while
the sleep timer is still counting down, press the SLEEP button once, "Sleep Off" will show
on the display.
4. Press the INFO button repeatedly to the display the sleep timer status.
The sleep function can be activated only in AC power operation.

System Reset

There may be times when you need to reset your unit back to the factory settings especially
when you have moved house. If you experience reception problems you may want to reset
and try again. If you move to another part of the country and pick up the local and national
DAB stations in that area, your previously tuned channels may no longer be available.
1. Press and hold the MENU button until the "Press SELECT to confirm reset" shows on
the display.
Press the TUNE/SELECT button to start the system reset, "Restarting..." will show on
2.
the display. After the reset is complete, the unit will go to standby mode.
3. Press the
scanning for DAB channels immediately.
After the system reset, all the tuned stations, DAB & FM
preset stations and alarm settings will be erased.
L55DAB10_IB_110810_Zell.indd 11
90 80 70
STANDBY button again to turn the unit on, the unit will then start
60 30 10
11
10/08/2011 10:44 AM