Preparing The Power Supply - Sony F35 Operation Manual

Attaching a viewfinder
When the supplied center handle is attached to the top of
the camera head, you can attach the viewfinder to the
viewfinder shoe of the center handle after removing the
viewfinder shoe from the camera head.
The procedure for attaching the viewfinder is the same as
when attaching it to the viewfinder shoe of the camera head
(see page 26).
2-8 Preparing the Power
Supply
This camera operates on DC 12 V (10.5 to 17 V).
Supplying power directly to the camera
head
Connect a power supply to the DC IN connector (LEMO
8-pin) of the camera head.
Use a commercially available shielded cable by attaching
the supplied 8-pin connector for a power cable.
For details on the connection, consult your local Sony
representative.
To turn on the camera
Set the CAM POWER switch of the camera head to the ON
side, and the camera is turned on.
Power is also supplied to viewfinders connected to the VF1
or VF2 connector and a device connected to the LENS
connector of the camera head.
Power of 12 V or 24 V can be fed to accessories via the DC
OUT connectors.
Supplying power via the interface box or
CA-F101
To supply power via the interface box (supplied) or a CA-
F101 Optical Fiber Camera Adapter (optional), mount the
interface box or the CA-F101 to the rear of the camera
head.
Connect a power supply to the DC IN connector (XLR 4-
pin) of the interface box or the CA-F101.
Note
If the the interface box or the CA-F101 is mounted on top,
power is not fed to the camera via the interface box or the
CA-F101.
To turn on the camera
Set the CAM POWER switch of the camera head to the CA
side, and the camera is turned on.
Power is also supplied to viewfinders connected to the VF1
or VF2 connector and a device connected to the LENS
connector of the camera head.
To use an AC power source
An AC power source can be connected, by using the AC-
DN2B AC Adaptor.
1
Attach the AC-DN2B to the interface box or the CA-
F101.
29

Preparing the Power Supply