Mounting The Interface Box - Sony F35 Operation Manual

Installation and
Preparations
2-1 Mounting the
Interface Box
The supplied interface box can be attached to the top or
rear of the camera head.
Connection between the camera head and the interface box
is achieved by mounting, eliminating additional cable
connections.
• The same attaching/detaching system is used both on the
top and the rear.
• The following instructions use the illustrations of
attaching the interface box to the rear as examples.
• Although the illustrations show the statuses where the L
handle has been detached, the interface box can be
mounted/unmounted with the L handle attached.
To attach
1
Place the camera head on a stable, flat surface.
2
Rotate the accessory clamp lever upward (toward the
lens when attaching to the top).
Accessory clamp lever
Chapter
3
Release the lock by sliding the lock-release knob in the
direction of the arrow (1 in the figure below) then pull
up the accessory mount lever (pull it toward the lens
when mounting on the top) (2 in the figure below).
Accessory mount lever
4
Aligning the matching line on the interface box with
that on the camera head, fit the interface box into the
camera head then push down on the box (slide it in the
opposite direction of the lens when attaching to the
top) so that the connectors engage.
Matching line on
the camera head
2
Lock-release knob
Matching line on
the interface box

Mounting the Interface Box

21