Signal Loss Reminder Setting; Backlight Setting; Resetting Your Hazard Alert Radio - Radio Shack 12-262 User Manual

1. Press MENU/SELECT and press  or  until
displays. Press MENU/SELECT to enable or disable it. (% displays
when enabled and
2. Press  to exit.
• Press any button to mute signal loss reminder alert. If a
signal is detected for less than 10 minutes and lost again, no
NOTE
signal loss reminder will sound.
• If the signal is lost ,
on the display. WARNING and ADVISORY alert LEDs flash
alternatively, and WATCH LED lights.
1. Press MENU/SELECT and press  or  to select
setting. Then, press MENU/SELECT.
ON OFF
2. Select ,
for 10 seconds when a key is pressed, an alert is received, or the AC
adapter is plugged in.
3. Press MENU/SELECT again and press  to exit.

resetting your hazard alert radio

1. Unplug the AC adapter and remove the backup batteries.
2. While holding down WEATHER/SNOOZE, plug the Hazard Alert
Radio's AC adapter into an outlet or install batteries.
displays and the radio beeps. Then release WEATHER/SNOOZE.
3. Press MENU/SELECT to clear the memory and restore the factory
DEFAULT
settings.
displays.
4. Unplug then plug in the AC adapter and install batteries.
LANGUAGE
displays. You must reinitialize the radio (see pages 2-3).
10

signal loss reminder setting

Í
displays when disabled.)
SIGNAL LOSS

backlight setting

AUTO
, or . If you select
displays. Wait 5 to 10 seconds until
SIG REMINDER
Ê
appears and
BACKLIGHT?
AUTO
, the backlight turns on
USER SETUP
USER SETUP
flashes
SET