Dish Network HDTV User Manual page 23

Add a UHF Attenuator
Stray UHF signals can block signals from the remote control to the receiver. To
prevent blocks, you can install a 10 dB attenuator. This will help keep out stray
UHF signals, but also reduces how far away you can use the remote control. The
attenuator is not supplied with this receiver.
1. Remove the UHF antenna from the
UHF Remote Antenna input on the
receiver back panel.
2. Attach a 10 dB attenuator to the UHF
Remote Antenna input.
3. Attach the UHF antenna to the
attenuator.
UHF Remote Control Antenna
Page 19