Beater To Bowl Clearance - KitchenAid COMMERCIAL MIXER Instructions Manual

Your Stand Mixer is adjusted at the factory so the flat beater just clears the
bottom of the bowl. If, for any reason, the flat beater hits the bottom of the
bowl or is too far away from the bowl, you can correct the clearance easily.
1. Unplug Stand Mixer.
2. Place bowl lift handle in down
position.
3. Attach flat beater.
4. Adjust so flat beater just clears
bottom surface of bowl when in
lifted position by turning screw (A)
clockwise to raise the bowl and
counterclockwise to lower the
bowl. Just a slight turn is all that is
required: the screw will not rotate
more than 1 ⁄ turn (90 degrees) in
4
either direction. The full range of
adjustment is
degrees.
5. Place bowl lift handle in up
position to check clearance.
6. Repeat steps 4 and 5 if necessary.
NOTE: When properly adjusted, the
flat beater will not strike the bottom
or side of the bowl. If the flat beater
or the wire whip is so close that it
strikes the bottom of the bowl, the
beater or whip may wear.

Beater To Bowl Clearance

1 ⁄ turn, or 180
2
10
A