45, 56, 73, 106 types
Part Name
Truss-head
Phillips
Tapping screw
4×20 mm
Truss-head
Phillips
Tapping screw
4×10 mm
Flare insulation
Table 1-4 (Floor Standing & Concealed Floor Standing)
Part Name
Figure
Connection
pipe
Flare insulator
Insulating tape
Insulating tape
Vinyl clamp
Insulating tape
(black and long)
Drain insulator
●
Use M12 for suspending bolts.
●
Field supply for suspending bolts and nuts.
2. SELECTING THE INSTALLATION SITE
2-1. Indoor Unit
AVOID:
●
areas where leakage of flammable gas may be expected.
●
places where large amounts of oil mist exist.
●
direct sunlight.
●
locations near heat sources which may affect the
performance of the unit.
●
locations where external air may enter the room directly. This
may cause "sweating" on the air discharge ports, causing
them to spray or drip.
●
locations where the remote controller will be splashed with
water or affected by dampness or humidity.
●
installing the remote controller behind curtains or furniture.
●
locations where high-frequency emissions are generated.
DO:
●
select an appropriate position from which every corner of the
room can be uniformly cooled.
●
select a location where the ceiling is strong enough to
support the weight of the unit.
●
select a location where tubing and drain pipe have the
shortest run to the outdoor unit.
●
allow room for operation and maintenance as well as
unrestricted air flow around the unit.
●
install the unit within the maximum elevation difference
above or below the outdoor unit and within a total tubing
length (L) from the outdoor unit as detailed in the installation
instructions packed with the outdoor unit.
●
allow room for mounting the remote controller about 1 m off
the floor, in an area that is not in direct sunlight nor in the
flow of cool air from the indoor unit.
NOT E
Air delivery will be degraded if the distance from the floor to the
ceiling is greater than 3 m (for D1 type, greater than 3.5 m).
Figure
Q'ty
Q
'
ty
Remarks
For connecting gas
1
tubes
For gas and liquid
2
tubes
For gas and liquid
2
(White)
tube flare nuts
For gas and liquid
2
(Black)
tubes
For ends of flare
7
insulator
1
For drain pipe
1
For drain hose joint
8
2
1
Floor Standing, Concealed Floor Standing
min.
100 cm
min.
5 cm
* For 45, 56, 73, 106 types
7
2-Way Cassette
1-Way Cassette
100
cm
20
cm
100
cm
min.
100 cm
min. 100 cm
Horizontal view
Wall Mounted
min. 15 cm
(min. 7.5 cm)*
Front View
Fig. 2-1
20
cm
20
cm
Fig. 2-2
min. 100 cm
Vertical view
Fig. 2-3
min.
5 cm
Fig. 2-4