Pace VPN-Lite User Manual page 8

b. Setting the DHCP Server: This task is optional. If you want your Pace 921VNX to act as a DHCP
server – distributing IPs to your LAN PCs – please perform this step.
Set the router's DHCP range to the correct target range using this command:
Syntax:
Example:
This router will now distribute IPs to connected PCs from the range 10.0.17.1 -> 10.0.17.254
Note: Alternatively, if you prefer to use static IPs on your network and you wish to disable the
router's DHCP server feature, please run these commands:
c. Set your router's LAN IP address: Please run the following command to set your router's LAN
IP address to within the correct target IP range. (Note that if using DHCP server, this LAN IP
must be in that same IP range).
Note that your telnet session will become unresponsive after you execute the command and will
eventually terminate. This is due to the router's altered LAN IP that was originally used to setup the
Telnet connection, but has now been changed.
Syntax:
Example:
Please see the correct LAN IP target range for your local site indicated on the VPN-Lite web
page screen shot below.
This will terminate Telnet session.
TELKOM VPN-Lite 2.5 ver.100712
cd LANDevice_1_HostConfig
set MinAddress <Min Address>
set MaxAddress <Max Address>
cd _
cd LANDevice_1_HostConfig
set MinAddress 10.0.17.1
set MaxAddress 10.0.17.254
cd _
cd LANDevice_1_HostConfig
set DHCPServerEnable 0
cd _
cd LANDevice_1_IPInterface_1
set IPAddress <LAN IP>
set SubnetMask <Subnet>
cd _
fcommit
cd LANDevice_1_IPInterface_1
set IPAddress 10.0.17.2
set SubnetMask 255.255.255.0
cd _
fcommit
Page 8