Vpn-Lite Manual Setup Using Telnet - Pace VPN-Lite User Manual

VPN-Lite Manual Setup Using Telnet

The following section will guide you to setup you VPN-Lite servise using the Telnet command line interface.
Before you start please refer to the Before you start section in this document see page 4.
1. IP Management:
a. Telnet to the Pace 921VNX using the router's LAN IP address (default = 10.0.0.2) using this
command: "telnet 10.0.0.2" or an application such as Putty for Windows 7 users.
This will access the Pace 921VNX's CLI interface allowing you to send setup commands. On
successful connection, you will be prompted for a login and password (defaults: admin &
nology*/). See screenshot below.
Enter your administration login & password. On successful authentication you will arrive at
the admin prompt. (See screenshot below.)
TELKOM VPN-Lite 2.5 ver.100712 Page 7