Wsw38 Function Setting 16, In V. 34 Mode - Brother MFC8500 Service Manual

Selector
No.
1
Setting of the equalizer
2
Sending level of guard tone at
3
phase 2
Stepping down the transmission
4
speed at fallback each
Automatic control of modem's
5
EQM gain for proper transmission
6
speed choice
Redialing when a communications
7
error occurs
8 Not used.
NOTE: WSW38 takes effect only in V. 34 mode.
Selectors 1 and 2: Setting of the equalizer
These selectors set the equalizer's training level to be applied if the facsimile equipment fails to
send training due to weak line connection. If these selectors are set to "0, X," the modem will
automatically set the appropriate training level.
Selector 3: Sending level of guard tone at phase 2
This selector sets the sending level of guard tone for 1800 Hz to be sent at Phase 2 in the V. 34
mode.
Selector 4: Stepping down the transmission speed at fallback each
This selector determines how much the modem steps down the transmission speed at fallback
when called by the remote station. If this selector is set to "1," the modem may step down the
transmission speed from 33600 bps to 28800 bps by one-time fallback.
Selectors 5 and 6: Automatic control of modem's EQM gain for proper transmission speed choice
These selectors determine how the modem controls the EQM (Eye Quality Monitor) gain for
proper choice of the transmission speed, which applies if the modem selects higher transmission
speed than the possible speed so that it always repeats falling back.
WSW38
(Function setting 16, in V. 34 mode)
Function
38
Setting and Specifications
No. 1 2
0 X : Automatic
1 0 : Fixed to 4 points
1 1 : Fixed to 16 points
0: Normal - 7 db
0: 2400 bps 1:
No. 5 6
0 0 : For higher transmission speed
than the current setting
0 1 : No change from the current
setting
1 0 : For lower transmission speed
than the current setting
1 1 : For further lower transmission
than the setting made by 1, 0
0: ON 1:
WWW.OASD.CN
1: Normal
4800 bps
OFF
WWW.OASD.CN