Specifications; Assembling The Blower - Shindaiwa Super Quiet EB480 Owner's Manual

SPECIFICATIONS

Model .............................................................................................. EB480 and EB500
Dimensions (L x W x H) ........................................................... 320 x 375 x 475 mm
Engine Type .................................. 2 cycle air cooled gas engine, vertical cylinder
Bore & Stroke ............................................................ 41 x 33 mm (1.6 x 1.3 inches)
Displacement ...................................................................... 43.6 cc (2.66 cu. inches)
Fuel .... Gasoline/oil mixture (40:1 with Shindaiwa Premium 2-cycle Engine Oil)
Carburetor ............................................ Walbro diaphragm-type with primer pump
Ignition ...................................................... All transistor electronic ignition system
Spark Plug ................................................................................ Champion CJ8 (EPA)
Starting ................................................................................................... Recoil starter
Stopping ........................................................................ Throttle lever (fuel shut-off)
Fuel Tank Capacity ......................................................................... 2.1 liters (71 oz.)
Exhaust System ..................................................................... Spark-arrestor muffler
Air Filtration ............................................................................................ Dry element
Weight (dry; without blower tubes), EB480 ................................. 9.0 kg (19.8 lbs)
Weight (dry; without blower tubes), EB500 ................................. 8.4 kg (18.5 lbs)
Specifications are subject to change without notice.
Standard Accessories
■ 90° Discharge Tube
■ Flexible Tube
■ Swivel Tube
■ Straight Tube
■ Nozzle Tube
■ Handgrip (removable)

ASSEMBLING THE BLOWER

1. Place the blower upright on the
ground or a sturdy work surface.
2. Fit the 90° discharge tube over the
blower outlet port, and secure with
the 115mm dia. clamp.
3. Slip the flexible tube over the
opposite end of the 90° discharge
tube, and secure with the 100mm
clamp.
4
NGK BMR6A (EMC)
■ Three Tube Clamps (115 mm,
100 mm, 85 mm)
Standard Tools
■ Spark Plug Wrench
■ Three Hex Wrenches
(3 mm, 4mm, 5mm)
4. Push the swivel tube into the
flexible tube, and then install and
tighten the 85mm clamp over the
rotating band on the swivel tube.
5. Slide the handgrip over the swivel
tube, and secure with the bolt,
washer, and nut.
Shin-Daiwa Kogyo Co., Ltd.
Federal Emission Design And Defect Limited Warranty
Utility And Lawn And Garden Engines
Shin-Daiwa Kogyo Co., Ltd. warrants to the initial purchaser and each
subsequent owner, that this utility equipment engine (herein engine) is
designed, built and equipped to conform at the time of initial sale, to all appli-
cable regulations of the U.S. Environmental Protection Agency (EPA), and that
the engine is free of defects in materials and workmanship that would cause
this engine to fail to conform with EPA regulations during its warranty period.
This emission warranty is applicable in all States, except the State of California.
For parts listed under PARTS COVERED, the dealer authorized by Shin-
Daiwa Kogyo Co., Ltd. will, at no cost to you, make the necessary diagnosis,
repair, or replacement of any defective emission-related component to ensure
that the engine complies with applicable U.S. EPA regulations.
MANUFACTURERS WARRANTY COVERAGE
When sold within the U.S., this engine's emission control system is warranted
for a period of two (2) years from the date this product is first delivered to the
original retail purchaser.
OWNER'S WARRANTY RESPONSIBILITIES
As the engine owner, you are responsible for the performance of the required
maintenance listed in your owner's manual. Shin-Daiwa Kogyo Co., Ltd.
recommends that you retain all receipts covering maintenance on your engine,
but Shin-Daiwa Kogyo Co., Ltd. cannot deny a warranty claim solely for the lack
of receipts or for your failure to ensure the performance of all scheduled
maintenance.
As the engine owner, you should however be aware that Shin-Daiwa Kogyo
Co., Ltd. may deny your warranty coverage if your engine or a part has failed
due to abuse, neglect, improper maintenance or unapproved modifications.
You are responsible for presenting your engine to the nearest dealer autho-
rized by Shin-Daiwa Kogyo Co., Ltd. when a problem exists.
If your Shindaiwa Dealer is unable to answer questions regarding your
warranty rights and responsibilities, you should then contact your Shindaiwa
Distributor.
For the name and telephone number of the Shindaiwa Distributor in your
area, please call Shindaiwa Inc. at (503) 692-3070 between the hours of 8:00 AM
and 5:00 PM Pacific Standard Time.
21