Lincoln Electric POWER WAVE MANAGER IM8002 Operator's Manual page 58

Chapter 7. Network Settings
For example, if the custom range is from 192.168.1.0 to 192.168.1.255, a computer whose IP address
is 192.168.1.10 will be able to access this machine, but a computer whose IP address is 192.168.2.1
will not.
Communications Setup Tab
Network speed (how fast your network can transmit data) and the duplex setting (the two-way
communication allowed on that network) dictate how effective the communication is between your
Welding Power Source and the network. The speed and duplex of the Welding Power Source should
match the speed and duplex of your network. Welding Power sources are shipped with default
settings that operate properly with most networks. You typically do not need modify this setting.
You have the following options if you ever need to make adjustments:
100 BaseT, Full Duplex (default)

10 BaseT, Full Duplex

100 BaseT, Half Duplex

10 BaseT, Half Duplex

STOP |
7.16
Figure 7.15 Communication Setup Tab
Assigning an incorrect network speed and duplex on the
Welding Power Source may cause it to become unreachable
on the network. If you are unsure about what values to
assign to the Welding Power Source, consult your network
administrator.
Power Wave® Manager User Manual
Ethernet
IM8002