Table of Contents
Advertisement
The following illustration shows the locations of parts on the system board.
Installing memory modules
Your computer has four connectors for installing dual inline memory modules
(DIMMs) that provide up to a maximum of 4.0 GB of system memory.
When installing memory modules, the following rules apply:
v Use 1.8 V, 240-pin, double data rate 2 synchronous dynamic random access
v Use 256 MB, 512 MB or 1.0 GB DIMMs in any combination.
Note: Only DDR2 SDRAM DIMMs can be used.
To install a memory module:
1. Remove the computer cover. See "Removing the cover" on page 10.
12
User Guide
1
Speaker connector
2
Memory connector 4
3
Memory connector 3
4
Memory connector 2
5
Memory connector 1
6
Front panel connector
7
Power supply connector
8
Parallel ATA IDE connector
9
System fan connector
10
SATA connectors (4)
11
PCI Express x16 graphics adapter
connector (some models)
memory (DDR2 SDRAM).
12
PCI adapter connector 1
13
PCI adapter connector 2
14
Serial connector 2
15
PCI Express x1 adapter connector
16
Clear CMOS/Recovery jumper
17
Battery
18
Microprocessor fan connector
19
Microprocessor
20
Microprocessor heat sink
21
12v power connector
22
Diskette drive connector
Advertisement
Table of Contents
