Replacing A Fuse; The Fcc Wants You To Know - Radio Shack AM/FM Stereo Cassette Player Owner's Manual

12-2117.fm Page 13 Thursday, February 24, 2000 11:21 AM
one side, then turn it over and complete-
ly fast-forward the other side. Loosen
the tape reels by gently tapping each
side of the cassette's outer shell on a flat
surface.
Caution: Be careful not to damage the
cassette when tapping it. Do not touch
the exposed tape or allow any sharp ob-
jects near the cassette.

REPLACING A FUSE

If the stereo does not operate, you might
need to replace an in-line fuse with the
supplied spare fuse.
Follow these steps to replace either of
your stereo's fuses.
Fuse
Holder
Metal
Holder
1. Disconnect the cable from your
vehicle's negative (–) battery termi-
nal.
2. To open either fuse holder, release
the two latches on the fuse holder
until it springs apart.
3. Slide off the metal holder on each
end of the fuse and remove the
fuse.
4. If the fuse is blown, replace it. Use
1
only standard 1
the proper rating. The red
Fuse
Metal
Holder
/ -inch fuses with
4
+12 TO
Care
wire's fuse must be 3
IGNITION
amps. The yellow
wire's fuse must be 0.5 amps.
Caution: The supplied spare fuses
have the correct rating. If you use a
fuse with an incorrect rating, the ste-
reo could be damaged.
5. Reassemble the fuse holder by
squeezing it together until it latches.
6. Reconnect the cable to the vehicle's
negative (–) battery terminal.
THE FCC WANTS YOU TO
KNOW
Your stereo might cause TV or radio in-
terference even when it is operating
properly. To determine whether your
stereo is causing the interference, turn
off your stereo. If the interference goes
away, your stereo is causing the interfer-
ence. Try to eliminate the interference
by:
• moving your receiver away from the
stereo
• contacting your local RadioShack
store for help
If you cannot eliminate the interference,
the FCC requires that you stop using
your stereo.
+12V TO BATTERY
13