Laser Control Panel Buttons; Leveling The Laser In Vertical Mode; Speed/Rotation Button; Standby Button - DeWalt DW074 Instruction Manual

NOTE: The head will begin or resume rotation once the laser is
level.
TURNING THE LASER ON IN VERTICAL MODE
(MANUAL LEVELING)
1. Gently press the power button (C) to power the laser on. The
power LED indicator light (H) will illuminate and the Standby
Mode LED (I) will begin to flash.
NOTE: The unit automatically enters Standby Mode when put
in Vertical Mode.
2. Manually level the unit using the four arrow buttons (F, G).
3. Gently press the standby button (E) or speed/rotation button (D)
to disengage Standby Mode.
4. Press the speed/rotation button (D) to select the desired rotation
speed.

LEVELING THE LASER IN VERTICAL MODE

1. Gently press the standby button (E) to engage Standby Mode.
CAUTION: To reduce the risk of direct eye exposure to the
laser beam, always engage Standby Mode before viewing the
bubble vial.
2. View the position of the bubble vial by sighting straight down
from above the unit.
NOTE: Viewing the bubble from any angle other than straight
down will result in an inaccurate reading.
3. Center the bubble exactly midpoint between the hatchmarks on
the vial. The bubble is adjusted by pressing the up and down
arrow buttons (F, G). The single arrow buttons move the bubble
slowly; the double arrow buttons allow fast adjustment of the
bubble.
4. Gently press the standby button (E) or speed/rotation button (D)
to disengage Standby Mode.
TURNING THE LASER OFF
Gently press the power button (C) to turn the laser off. The power
LED indicator light (H) will no longer be illuminated.

Laser Control Panel Buttons

POWER BUTTON
Press the power button (H) to power the unit on and off.
ARROW BUTTONS
The arrow buttons (F, G) are used to adjust/level the bubble in
the vial. The single arrow buttons (F) move the bubble slowly; the
double arrow buttons (G) allow fast adjustment of the bubble.

SPEED/ROTATION BUTTON

The speed/rotation button (D) is used to adjust the rotation speed
of the laser beam through its 3 preset speeds.
The head speed will cycle through 3 speeds, then repeat the
sequence as the speed/rotation button is pressed.
REMEMBER:
Slow speed = Bright Beam

STANDBY BUTTON

Press the standby button (E) to engage Standby Mode. This turns
off the laser beam and stops the laser head from rotating. The
standby LED indicator light (I) will flash when the unit is in Standby
Mode.
NOTE: Pressing any of the arrow buttons (F, G) will also engage
Standby Mode.
CAUTION: To reduce the risk of direct eye exposure to the laser
beam, always engage Standby Mode before viewing the bubble
vial.
5
Fast Speed = Solid Beam