Two-Stage Door Unlock; Activating The Trunk Release Feature; Using The Progressive Car Finder Feature; Personal Protection Alarm (Panic) - Code Alarm PowerCode PC 6100 Owner's Manual

5
Using Your Remote Transmitter
(cont.)

Two-Stage Door Unlock

If this feature is enabled on your system, pressing UNLOCK one time
will unlock only the driver's door. Press UNLOCK again within 1 minute
to unlock all doors.

Activating the Trunk Release Feature

Press and hold TRUNK to open the vehicle trunk or hatch (if equipped
and connected). If this button is used to operate another accessory,
the accessory will stay active for as long as the button is held.
Using the Auxiliary Function
Press and hold the LOCK button to turn on the Auxiliary Function (if enabled).

Using the Progressive Car Finder Feature

Press FIND on the remote control to locate your vehicle. The horn will
emit five short "honks" at low volume, increasing in volume each of
three times the button is pressed.

Personal Protection Alarm (Panic)

Press and hold the PANIC button to activate the vehicle horn and parking
lights for 30 seconds. (If the vehicle horn is connected, the horn will "honk" for
30 seconds.) Press any remote control button to turn off the Panic alarm.
Using Second Car Mode
If this feature is enabled, one transmitter will control two vehicles equipped
TM
with a Power Elite system. To operate the second vehicle, press the shift
button, then within two seconds, press the desired function button.