Comfort Adjustments - Pride Mobility Travel scooter series Owner's Manual

V . C O M F O R T A D J U S T M E N T S
TILLER ANGLE ADJUSTMENT (See figure 17)
WARNING! Remove the key from the key
switch before adjusting the tiller or the seat.
Never attempt to adjust the tiller or the seat
while the Travel Scooter is in motion.
NOTE: In order to fully lower the tiller, you must first
remove the seat and battery pack. Remove the seat by pulling
it straight up and off of the Travel Scooter.
SEAT ROTATION ADJUSTMENT
The seat rotation lever, located on the right side of the seat
base, secures the seat into several positions. See figure 18.
1. Pull up on the seat rotation lever to disengage the seat.
2. Rotate the seat to the desired position.
3. Release the lever to secure the seat into place.
ARMREST WIDTH ADJUSTMENT
The armrest width can be adjusted inward or outward.
1. Loosen the armrest adjustment knobs. See figure 18.
2. Use the attached ring to pull and remove the detent pins.
3. Slide the armrests in or out to the desired width.
4. Align the adjustment holes on the seat frame and armrest,
then reinsert the detent pins.
5. Tighten the armrest adjustment knobs.
NOTE: Pivot the armrests upward to aid in getting onto and
off of your Travel Scooter.
SEAT HEIGHT ADJUSTMENT
The seat can be repositioned to different heights. See figure 19.
1. Remove the seat and battery pack from your Travel
Scooter.
2. Use the attached ring to pull and remove the detent pin
from the lower seat post.
3. Raise or lower the upper seat post to the desired seat
height.
4. While holding the upper seat post at that height, align the
adjustment holes of the upper and lower seat posts.
5. Fully insert the detent pin.
6. Replace the battery pack and seat.
Travel Scooter Series
Figure 17. Tiller Adjustment Knob
IDENTIFICATION KEY
1. Armrest Adjustment Knobs
2. Detent Pins
3. Seat Rotation Lever
2
Figure 18. Seat Adjustments
IDENTIFICATION KEY
1. Upper Seat Post
2. Lower Seat Post
3. Detent Pin
Figure 19. Seat Height Adjustment
3
1
1
2
3
21