Factory Default Settings - NETGEAR Nighthawk EX7000 User Manual

Factory Default Settings

To reset the extender to factory default settings, you can use either the Reset button on the
rear panel or the Erase function. For more information, see
Default Settings on page 44.
The following table shows the factory default settings.
Table 5. Factory default settings
Feature
Smart Setup
WiFi communication
WiFi network name (SSID)
Security
Transmission speed
Country/region
Operating mode
Data rate in the 2.4 GHz band
Data rate in the 5 GHz band
DHCP
1. Maximum WiFi signal rate (IEEE Standard 802.11). Actual throughput can vary. Network conditions and
environmental factors, including volume of network traffic, building materials and construction, and network
overhead lower actual data throughput rate.
AC1900 WiFi Range Extender
Default Settings
Enabled
Enabled
NETGEAR_EXT
Disabled
1
Auto
Varies by region
802.11a/b/g/n/ac
Up to 600 Mbps
Up to 1300 Mbps
Client enabled
Factory Settings and Technical Specifications
75
Return the Extender to Its Factory