Basic Position Of The Machine Drive Unit; On Machines With Picodrive And Control Unit P44 Pd-L - Pfaff 571 Instruction Manual

Installation and commissioning
8

Basic position of the machine drive unit

.09
8

On machines with PicoDrive and control unit P44 PD-L

.09.01
● Switch on the machine.
● Call up the parameter input by pressing the "scroll" key.
● To switch the function keys to input (LED in the TE key lights up), press the TE key.
● By pressing the corresponding +/- keys, select parameter "798" and service level C,
● Select parameter "799" by pressing the corresponding +/- keys.
● Check whether the value on the 571 and 591 is set at "4" and on the 574 at "6" and alter if
● Switch the machine off and then on again.
● Select parameter "800" by pressing the corresponding +/- keys.
● Check whether the value is set at "1" (balance wheel turns towards the operator) and alter
● Select parameter "802" by pressing the corresponding +/- keys.
● Check whether the value is set at "0" on the 571 and 591 (= no gear reduction) and at "1"
● By pressing the corresponding +/- key, select parameter "700"
● Sew a stitch by operating the pedal.
● Turn the balance wheel in the sewing direction until the descending needle is level with
● Conclude the adjustment of the sewing motor by pressing the TE/Speed key.
28
see Chapter Selecting the User Level in the separate Control Panel Instruction Manual.
necessary.
if necessary.
on the 574 (= gear reduction), alter if necessary.
the top edge of the needle plate.