Customer Responsibilities; Maintenance; To Drain Tank - Stanley N128677 Instruction Manual

CUSTOMER RESPONSIBILITIES

Check Safety Valve
Drain Tank
Remove tank from service
1- For more information, call 1 -800-262-2161
Risk of Unsafe Operation. Unit cycles automatically when power is on.
When performing maintenance, you may be exposed to voltage sources, compressed
air or moving parts. Personal injuries can occur. Before performing any maintenance or
repair, disconnect power source from the compressor and bleed off all air pressure.
NOTE: See Operation section for the location of controls.
TO CHECK SAFETY VALVE
Risk of Bursting. If the safety valve does not work properly, over-
pressurization may occur, causing air tank rupture or an explosion.
Risk from Flying Objects. Always wear certified safety equipment: ANSI
Z87.1 eye protection (CAN/CSA Z94.3) with side shields.
1. Before starting compressor, pull the ring on the safety valve to make
sure that the safety valve operates freely. If the valve is stuck or does not
operate smoothly, contact a trained service technician.

TO DRAIN TANK

Risk of unsafe operation. Air tanks contain high pressure air. Keep face
and other body parts away from outlet of drain. Use eye protection [ANSI Z87.1 (CAN/
CSA Z94.3)] when draining as debris can be kicked up into face.
Risk from noise. Use ear protection (ANSI S12.6 (S3.19) as air flow noise
is loud when draining.
NOTICE: Allow unit to cool before
draining tank, drain valve becomes
hot during operation.
1. Set the Off/Auto switch to "OFF".
2. Turn the regulator knob counter-
clockwise to set the outlet pressure
to zero.
3. Pull and hold ring on safety valve
allowing air to bleed from the tank
until air pressure is minimized.
4. Place unit on blocks to lift unit off
of ground. (Fig. 7)
5. Place suitable container under unit to catch water.

MAINTENANCE

Before Daily or
after each
each
use
use
●
●
15 - ENG
See tank warning label
●
1
7