Tool Operation Check - Bostitch HP118K Operation And Maintenance Manual

CAUTION: Remove all fasteners from tool before performing tool operation check.
TRIGGER OPERATION WITH A SECONDARY TRIGGER:
The primary trigger is located under the trigger valve. It can actuate the tool only if the secondary trigger has
already been pulled.
The secondary trigger is located under the handle. The secondary trigger prevents the primary trigger from
actuating the tool if the secondary trigger has not been pulled first.
Place the nose of the tool against a work piece for all of the following operation checks.
A. With hand on rear end of the handle, further back away from the secondary trigger, and not squeezing
the secondary trigger, use finger to pull the primary trigger.
THE TOOL MUST NOT CYCLE.
B. With hand on handle, and squeezing the secondary trigger, use finger to pull the primary trigger.
THE TOOL MUST CYCLE.
CAUTION: WHILE THE SECONDARY TRIGGER REMAINS SQUEEZED, THE TOOL WILL CYCLE
EACH TIME THE PRIMARY TRIGGER IS PULLED!
IN ADDITION TO THE OTHER WARNINGS CONTAINED IN THIS MANUAL
OBSERVE THE FOLLOWING FOR SAFE OPERATION
• Use the BOSTITCH pneumatic tool only for the purpose for which it was designed.
• Never use this tool in a manner that could cause a fastener to be directed toward the user
or others in the work area.
• Do not use the tool as a hammer.
• Always carry the tool by the handle with hand off both triggers. Never carry the tool by the air hose.
• Do not alter or modify this tool from the original design or function without approval
from BOSTITCH
• Always be aware that misuse and improper handling of this tool can cause injury to
yourself and others.
• Never clamp or tape the trigger or secondary trigger in an actuated position.
• Never leave a tool unattended with the air hose attached.
• Do not operate this tool if it does not contain a legible WARNING LABEL.
• Do not continue to use a tool that leaks air or does not function properly. Notify your
nearest BOSTITCH representative if your tool continues to experience functional problems.
PRIMARY TRIGGER

TOOL OPERATION CHECK:

SECONDARY TRIGGER
-11-