Removing The Display Screen And Completing The Procedure - Cisco TelePresence System 3200 Use & Care Manual

Chapter 12 Field-Replaceable Unit Guide

Removing the Display Screen and Completing the Procedure

Detach the display screen's signal cable from the correct codec unit.
Step 1
See
Detach the display screen's power cable from the correct PDU.
Step 2
See
Remove the black tape from the seam behind and between the display screens.
Step 3
Remove the left and right Display tilt brackets from the Display shelf supports.
Step 4
Using a minimum of two people, lift the Plasma display straight up to disengage the hooks on the back
Step 5
of the display from the horizontal mounting rod on the Display structure.
Move the Plasma display out of the work area to a temporary location safe from potential damage.
Step 6
Unpack the new display.
Step 7
Note
Turn the power switch on the Plasma display to the On position and make sure the cables are unbundled
Step 8
and hanging freely. Once the display is hung, these items may not be accessible.
Hang the replacement Plasma display.
Step 9
Plug in the signal cable to the correct codec.
Step 10
SeeChapter 9, "Routing Power and Signal Cables."
Plug in the power cable to the correct PDU.
Step 11
See
Step 12 Align and level the display and add the black seam tape.
See
Step 13 If required, attach the camera cluster.
See
Power and Signal Cables."
Step 14 Reassemble the display shelf sections.
See
Hang the speaker boards.
Step 15
See
Power on the system by completing the steps in the
Step 16
Reattach the projector screen.
Step 17
The projector screen comes with printed instructions that should assist you with replacing it. If you
Tip
cannot find the instructions, reverse the order of removal to install it.
Reassemble the left door tabletop section.
Step 18
See
OL-14521-01
Chapter 9, "Routing Power and Signal Cables"
Chapter 9, "Routing Power and Signal Cables"
Take care to minimize damaging the packaging material so it may be reused to package the old
display screen.
Chapter 9, "Routing Power and Signal Cables."
Chapter 3, "Mounting and Leveling the Plasma Displays."
Chapter 8, "Assembling the Remaining Cisco TelePresence Elements"
Chapter 5, "Building the Display Shelf Assembly."
Chapter 8, "Assembling the Remaining Cisco TelePresence Elements."
Chapter 6, "Building the First Row Table Assembly."
Replacing a Plasma Display—Part Number CTS-DISP-65-GEN2
for cable locations and reference.
for cable locations and reference.
and
"Powering On the System" section on page
Cisco TelePresence System 3200
Chapter 9, "Routing
12-1.
12-7