Transmitter Battery Replacement - Prestige APS-OE2B Programming Manual

12. Press and hold the Arm/Disarm Icon and Option transmitter but-
tons simultaneously until the sounding device emits a long beep,
indicating the signal has been stored into memory.
13. If you have additional transmitters ( up to 4 ) that need to be
programmed, repeat step 12 for each transmitter.
14. Turn the ignition key off. The sounding device will emit one short
beep followed by one long beep indicating the system has
terminated the program mode.

TRANSMITTER BATTERY REPLACEMENT

You will notice a decrease in transmitter range as the battery condition
deteriorates. Transmitter battery replacement is recommended at least
every 10 to 12 months, depending upon how frequently the transmitter is used.
The transmitter has a small red LED built into the case. This LED can
be used to indicate battery condition. If the LED does not illuminate,
then the battery is discharged, and must be replaced.
To replace the transmitter battery,
1. Remove the small phillips head screw from the bottom cover of the
transmitter.
2. Carefully unsnap the top cover of the transmitter from the bottom cover.
3. Remove the discharged battery, making note of the location of the +
and - contacts, and replace with a new type GP 23A 12 volt battery.
4. Replace the transmitter cover, taking care not to damage the LED or
switches on the circuit board, and secure with the small phillips
head screw.
128-5544A
3 OF 4