Download Print this page

Prestige APS-OE2B Programming Manual page 2

Advertisement

Available languages

Available languages

PROGRAMMING THE TRANSMITTERS
It is important to remember that during programming, each individual
step of the procedure must be executed within 15 seconds of the
previous step.
When the 15 second time limit is allowed to expire, the system will
automatically terminate the programming mode. This is indicated by a
long chirp from the siren.
Additionally, the system will store codes from up to four different
transmitters. If a 5th transmitter is programmed to any receiver chan-
nel, then the first transmitter programmed to that channel will be erased
from the system's memory.
To program new or additional transmitters, the alarm must be
disarmed and the valet switch must be in the " off " position:
1. Enter the vehicle, and turn the ignition key to the " on " position.
2. Flip the valet switch on - off - on - off - on - then off.
3. The dash LED will flash one time, and the sounding device will
beep one time, indicating the system is ready to accept programming
for receiver channel 1.
4. Press and hold the Arm/Disarm Icon button until the sounding device
emits a long beep, indicating the signal has been stored into memory.
5. If you have additional transmitters ( up to 4 ) that need to be
programmed, repeat step 4 for each transmitter.
APS-33 No Further Programming Required.
6. Activate the valet switch on then off.
7. The dash LED will flash two times, and the sounding device will
beep two times, indicating the system is ready to accept programming
for receiver channel 2.
8. Press and hold the Option transmitter button until the sounding device
emits a long beep, indicating the signal has been stored into memory.
9. If you have additional transmitters ( up to 4 ) that need to be programmed,
repeat step 8 for each transmitter.
10. Activate the valet switch on then off.
11. The dash LED will flash three times, and the sounding device
will beep three times, indicating the system is ready to accept
programming for receiver channel 3 (only available on certain mod
els).
128-5544A
2 OF 4

Hide quick links:

Advertisement

loading