Assembly And Adjustments - DeWalt DW862 Instruction Manual

A. Shoe
B. Trigger switch
C. Lock-off button
D. Diamond blade
E. External flange
F. Clamping screw
G. Water tubing
H. Tool inlet
Trigger Switch (Fig. 1, 2)
WARNING: To avoid the possibility of the appliance plug or
receptacle getting wet, position the saw to one side of a wall mounted
receptacle to prevent water from dipping onto the receptacle or plug.
The user should arrange a "drip loop" in the cord connecting the saw
to a receptacle (Fig. 2). The "drip loop" is that part of the cord below
the level of the receptacle, or the connector if an extension cord is
used, to prevent water traveling along the cord and coming in contact
with the receptacle.
FIG. 2
CAUTION: Before plugging in tool, always check to see that the
switch actuates properly and returns to the OFF position when
released.
I. Water tubing adapter
J. Water valve lever
K. Tapping screw
L. Forked water valve
M. Depth adjustment lever
N. Brush covers
O. Brush assembly
WARNING: This tool has no provision to lock the trigger switch in
the ON position and should never be locked ON by any other means.
Release the trigger switch lock-off button (C) by pressing the button.
Pull the trigger switch (B) to turn the motor on. Releasing the trigger
switch turns the motor off.

ASSEMBLY AND ADJUSTMENTS

WARNING: To reduce the risk of injury, turn unit off and
disconnect tool from power source before installing and
removing accessories, before making any adjustments or
removing/installing attachments or accessories. An accidental
start-up can cause injury.
WARNING: Prior to assembly and adjustment, always unplug tool.
To Install the Diamond Blade (Fig. 3)
1. Place saw on a stable surface.
2. Place blade (D) on spindle.
FIG. 3
F
D
E
3. Using the flange wrench provided, hold the external flange (E)
4. Turn the clamping screw (F) counterclockwise to tighten. Use the
hex wrench provided to secure tightly.
5. To remove the blade, reverse this procedure.
24