Optional Accessories - DeWalt DWV902L User Manual

(NOTE: Reference to National
Regulations is necessary.)
Filter (fig. 1, 9, 10)
FILTER CARE
The filters included with this vacuum are long life
filters. To be effective in minimizing dust recirculation,
the filters MUST be installed correctly and in good
condition.
WARNING: Appropriate personal
protective equipment like dust mask
and gloves should be used while
handling the filters.
To Remove Filters
1. Turn on/off/tool control switch (o) to the OFF
position (O) and unplug cord from outlet.
2. Release canister latches (d) and remove
vacuum head (c) from canister. Place vacuum
head on a level surface upside down.
3. Turn each filter (i) counterclockwise by gripping
it on the plastic end cover as shown, and
carefully remove from head, ensuring debris
does not fall into mounting hole.
NOTE: Use care to not damage filter material.
4 If the bottom side of the vacuum head (c) needs
to be cleaned, use a cloth dampened with
water and mild soap and allow it to dry. Dispose
of cloth in an appropriate container.
5. Inspect filters for wear, tears or other damage.
NOTE: If there is any doubt on the condition
of the filters they MUST be replaced. DO NOT
continue use if filters are damaged.
WARNING: Never use compressed
air or a brush to clean filters, otherwise
damage to the filter membrane will
occur which will allow dust to pass
through the filter. If needed, gently tap
against a hard surface or rinse with
room temperature water and let air
dry. Cleaning of the filters is typically
unnecessary, even if the filter is
covered with dust. The automatic filter
cleaning system will maintain maximum
performance and continue to function.
If visual damage to the filter membrane
exists, replace filters. Filters typically
last between six and twelve months
depending on use and care.
To Install Filters
1. Ensure filter seal (aa) is in place and is secure
2. Line up filter threads (z) to vacuum head threads
and using moderate force, turn filter clockwise
until tight.
NOTE: Use care to not damage filter material.
3. Place the vacuum head (c) onto the container
and secure it by closing the canister latches (d).
Lubrication
Your appliance requires no additional lubrication.
Cleaning
WARNING: Never use solvents or other
harsh chemicals for cleaning the non-
metallic parts of the appliance. These
chemicals may weaken the materials
used in these parts. Never let any liquid
get inside the machine; never immerse
any part of the appliance into a liquid.
1. Vacuum the outside of the dust extractor. For
further cleaning use a cloth dampened only with
water and mild soap if necessary.
2. After use dispose of cloth in an appropriate
container.
Storage (fig. 11)
1. Empty the canister, refer to To Empty Canister
under Operation.
2. Clean the vacuum inside and outside. Refer to
Cleaning.
3. Clean or replace filters, refer to Filters.
4. Store the suction hose and the power cord as
shown in the illustration. Place the unit in a dry
room and secure it from unauthorized use.
NOTE: Plug inlet plug (s) into inlet (j) to keep
debris inside canister when suction hose is
removed. You can also attach the ends of the
hose together and lock together with the twist-
lock end.

Optional Accessories

WARNING: Since accessories, other
than those offered by D
not been tested with this product, use
E N GL IS H
WALT, have
e
9