Optional Accessories; Troubleshooting - DeWalt DWV902L User Manual

To Install Filters
1. Ensure filter seal (aa) is in place and is secure
2. Line up filter threads (z) to vacuum head threads
and using moderate force, turn filter clockwise
until tight.
NOTE: Use care to not damage filter material.
3. Place the vacuum head (c) onto the container
and secure it by closing the canister latches (d).
Lubrication
Your appliance requires no additional lubrication.
Cleaning
WARNING: Never use solvents or other
harsh chemicals for cleaning the non-
metallic parts of the appliance. These
chemicals may weaken the materials
used in these parts. Never let any liquid
get inside the machine; never immerse
any part of the appliance into a liquid.
1. Vacuum the outside of the dust extractor. For
further cleaning use a cloth dampened only with
water and mild soap if necessary.
2. After use dispose of cloth in an appropriate
container.
Storage (fi g. 11)
1. Empty the canister, refer to To Empty Canister
under Operation.
2. Clean the vacuum inside and outside. Refer to
Cleaning.
3. Clean or replace filters, refer to Filters.
4. Store the suction hose and the power cord as
shown in the illustration. Place the unit in a dry
room and secure it from unauthorized use.
NOTE: Plug inlet plug (s) into inlet (j) to keep
debris inside canister when suction hose is
removed. You can also attach the ends of the
hose together and lock together with the twist-
lock end.

Optional Accessories

WARNING: Since accessories, other
than those offered by D
not been tested with this product, use
of such accessories with this appliance
could be hazardous. To reduce the risk
of injury, only D WALT recommended
E
accessories should be used with this
product.
ACCESSORIES
DWV9310-XJ Filter
DWV9315-XJ Crush-proof hose
DWV9316-XJ Anti-static hose
DWV9401-XJ Paper bag
DWV9400-XJ Plastic liner
DWV9402-XJ Fleece bag
D WALT AirLock System
E
DWV9000 Twist-Lock
connection
DWV9110 29-35 mm tapered
rubber adapter
DWV9120 35-38 mm stepped
rubber adapter
DWV9130 35 mm OD adapter
DWV9150 35 mm OD angle
adapter
SECURING THE POWER CORD TO THE HOSE (FIG. 1)
The power cord (b) can be secured to the suction
hose (g) using the D279058CL hose clip (available
from your local D WALT supplier).
E
Consult your dealer for further information on the
appropriate accessories.

Troubleshooting

PROBLEM SOLUTION
Motor Check power cord, plugs and outlet.
does not
Ensure the on/off /tool control switch
run
is in the ON position ( ).
Suction Remove blockages in the suction
capacity nozzle, suction tube, suction hose
decreases or filters.
Replace the paper or fleece bag.
Check for proper installation of the
filters.
Clean or replace the filters.
Empty canister, refer to Empty
Canister under Operation.
EN G LI SH
WALT, have
E
31