Hole Punch Test
This test verifies that media can be fed to the finisher output bin and then hole punched. The printer feeds eight pieces
of blank media to the finisher and then the pages are hole‑punched with a 2‑hole, 3‑hole, or 4‑hole pattern, depending
on the selected punch test.
To run this test:
1
From the Diagnostics menu, navigate to:
Finisher Tests > Hole Punch Test
2
Select one of the following:
•
2 Punch Test
•
3 Punch Test
•
4 Punch Test
Hole Punch Test Running... appears while the test is running.
Feed Test (finisher)
This test verifies that media can be fed from the default source to a finisher output bin. Any size paper that is supported
can be used. The printer feeds one blank sheet of media from the default paper source to the finisher output bins.
To run this test:
1
From the Diagnostics menu, navigate to:
Finisher Tests > Feed Test
2
Select the output bin, and press .
Feed Tests Running... appears while the test is running.
Finisher Sensor Test
This test determines if the finisher sensors are working correctly. The sensors that are tested include the following:
•
Bin Level
–
Finisher Bin Empty
–
Bin Full sensor
–
Bin Near Full
•
Cover and Door
–
Side Door sensor
•
Pass and Media
–
Finisher Passthru
–
Media sensor
•
Staple Sensors
–
Cartridge Presence sensor
–
Staple Low sensor
–
Self-priming sensor
–
Home Signal sensor
Service menus
230
4063