Table of Contents
Advertisement
S
INSTALLATION PROCEDURE
Stage 1: Drilling the mounting holes for the metal chassis
assembly
Tamper switch and anti-theft function provide a part of the security
of the terminal.
Anti-theft function is realized with a block placed on the wall, and
hiding the opto light.
In order to satisfy the security profile of the MorphoAccess™
Maxx1 as a high level of security, a connection may be done
towards the supervisor system.
Only the connected mode provides the high security level
required for this terminal.
Standalone mode cannot be so secured.
a) Drill the 2 holes for the screws for the mounting keyholes so
b) Drill the hole for the third screw in the center of the slot so that
c) The mounting screws must be 5 mm diameter maximum.
d) Drill the hole for the srew, for the anti-theft block, as mentioned
Stage 2: Mounting the metal chassis assembly
a) Disconnect the ribbon cable between the motherboard and the
b) Pass the connecting cables through the cable entry.
c) Position the chassis assembly against the wall using the two
d) Hold the chassis in place with a screw through the mounting
e) Adjust the position, and fix in place by tightening all three
6
SAGEM SA document. Reproduction and disclosure forbidden.
that the cable entry is in a suitable position for your cabling,
using the dimensional drawing above (See the section Drilling
Template).
it is possible to correct the position later, if necessary.
on the view.
terminal block board so that the assembly shown above can be
detached from the rest of MorphoAccess™.
screws in the mounting keyholes.
slot.
screws.
E
SK-0000011322-02
Advertisement
Table of Contents
