Technical Specifications; Led Specifications - Fortinet FortiExtender 100B Quick Start Manual

Technical Specifications

1
5
4
# Interface Type Description
1 USB USB-A USB port for connection to your modem.
2 Console RJ-45 Not in use.
3 Ethernet Port RJ-45 Gigabit Ethernet port with PoE support up to 7.3W.
Default IP address: 192.168.1.2
4 AP/Bridge RJ-45 PoE output. Provides 48V DC and network
connectivity.
5 Ground Copper Electrical ground connection for the the PoE Injector.
6 Network RJ-45 Connection to the network.
7 DC In Provides 48V DC to the PoE injector.
100-240V AC, 50-60Hz, 1.5A max adapter
2 3
6
7
Page 8

LED Specifications

1 2 3 4 5
# LED State Description
Green The unit is on.
1 Power Flashing Green The unit is booting up.
Off The unit is off.
Green The unit has successfully connected to the
controller and ISP.
Flashing Green The unit is connecting to the ISP.
2 Status Amber The unit has successfully connected to the
controller but not the ISP.
Flashing Amber The unit is connecting to the controller.
Off The unit is not connected.
Green Port is connected at 1Gbps.
Amber Port is connected at 10/100Mbps.
Flashing Green Port is transmitting and receiving data at 1Gbps.
3 LAN
Flashing Amber Port is transmitting and receiving data at
10/100Mbps.
Off Port is not in use.
Green USB device recognized.
Amber USB device not active or disabled.
4 USB
Flashing Amber USB device not recognized or has an error.
Off No device connected or port disabled.
Off No signal, or signal indicator not supported for this
USB device.
1 Bar Weak signal.
Signal
5
Strength 2 Bar Okay signal.
3 Bar Good signal.
4 Bar Strong signal.
Page 9