Pro-Form ZT6 User Manual page 11

6 . Set a Handrail (84) onto the Right Upright (90).
Make sure that the Upright Wire (81) is not
pinched.
Attach the Handrail (84) with two 5/16" x 2 1/4"
Screws (28) and two 5/16" Star Washers (11).
Start both Screws, and then tighten them.
Attach the other Handrail (not shown) in the
same way. Note: There is no wire on the left
side.
Remove and discard the two indicated screws
(A) from both Handrails (84) (only one side is
shown).
7. Set the console assembly face down on a soft
surface to avoid scratching the console assem-
bly. Remove and save the four 1/4" x 1/2"
Screws (2). They will be used in a later step.
Identify the Left Tray (36) with the writing on
the bottom. Attach the Left Tray with four #8 x
1/2" Screws (1). Start all four Screws, and then
tighten them. Be careful not to overtighten the
Screws.
Attach the Right Tray (27) in the same way.
6
A
84
81
7
2
11
28
11
90
1
1
1
36
1
Console
Assembly
2
27