Pro-Form 850 PFEL77807.0 User Manual page 7

3. Identify the Upright (3) and orient it as shown.
Have a second person holds the Upright near
the top of the Frame (1). Locate the wire tie
(see the inset drawing) in the Upright. Tie the
lower end of the wire tie to the Wire Harness
(46). Next, pull the upper end of the wire tie
upward out of the top of the Upright. Then, untie
and discard the wire tie. Tip: Do not allow the
Wire Harness to fall into the Upright. Use a
piece of tape or an elastic band to hold the
Wire Harness in place until step 4.
Tip: Avoid pinching the Wire Harness (46)
during this step. Insert the Upright (3) into the
Frame (1). Attach the Upright with four M8 x
19mm Patch Screws (65).
4. While a second person holds the Console (4)
near the Upright (3), connect the console wire to
the Wire Harness (46). Insert the excess wire
downward into the Upright.
Tip: Avoid pinching the wires during this
step. Attach the Console (4) to the Upright (3)
with four M4 x 16mm Screws (80).
3
46
65
1
Wire Tie
46
4
46
7
Avoid pinching the
Wire Harness (46)
during this step
3
65
Avoid pinching the
wires during this step
4
Console Wire
3
80