Lower Tension Idler; Unwind Brake Tensioner; Supply Shaft; Core Chucks - GBC 2064WF-1 Installation And Operating Manual

GBC 2064WF-1
FIGURE 8
FIGURE 9
FIGURE 10
FIGURE 11
© 2009 General Binding Corporation an ACCO Brands CO.
Lower Tension Idler: (Fig.8A&9A) Lower Tension Idler: (Fig.8A&9A)
The Lower Tension Idler Guides the lower The Lower Tension Idler Guides the lower
lamination onto the Bottom Main Roller insuring a lamination onto the Bottom Main Roller insuring a
constant amount of wrap on the Bottom Main constant amount of wrap on the Bottom Main
Roller. Roller.

Unwind Brake Tensioner:

Unwind Brake Tensioner:
The Unwind Brake Tensioner (Fig.8B) is used to The Unwind Brake Tensioner (Fig.8B) is used to
adjust the amount of brake that is being applied to adjust the amount of brake that is being applied to
the film or media. the film or media.

Supply Shaft:

Supply Shaft:
The Supply Shaft (Fig.8C&9A) is used to hold The Supply Shaft (Fig.8C&9A) is used to hold
film to be used, and to apply brake tension. film to be used, and to apply brake tension.
Core Chuck: Core Chuck:
Bi-Directional Core Chucks (Fig.8D) grip the Bi-Directional Core Chucks (Fig.8D) grip the
Medias supply tube. Medias supply tube. Our patented roller core Our patented roller core
chuck will allow the operator the ability to add or chuck will allow the operator the ability to add or
remove film with ease. remove film with ease.
Unwind Brake Tensioner: Unwind Brake Tensioner:
The Unwind Brake Tensioner (Fig.10A) is used The Unwind Brake Tensioner (Fig.10A) is used
to adjust the amount of brake that is being applied to adjust the amount of brake that is being applied
to the film or media. to the film or media.
Cooling Fan Bridge: (Fig.11A) Cooling Fan Bridge: (Fig.11A)
There are 3 internal Cooling Fans. The fans can There are 3 internal Cooling Fans. The fans can
be used to cool down media while it passes be used to cool down media while it passes
through the Main Rollers and into the Pull Rollers. through the Main Rollers and into the Pull Rollers.
Rewind Tubes: Rewind Tubes:
The Rewind Tubes (Fig.11B) are used to rewind The Rewind Tubes (Fig.11B) are used to rewind
release liners or finished Medias. release liners or finished Medias.
Operation Manual
Page 12