2.5 Switching frequency band
The DJ-X2000 uses a dual VFO system, so that a frequency change can be done
smoothly by inputting a new frequency on the second band in advance. The
frequency currently being monitored is displayed next to the capital letter on the
top line of the display. Frequency band can be switched as follows.
2.6 Copying frequencies from one band to
the other
The frequency on the currently used band can be copied into the other band as
follows.
2.7 Scanning
Scanning is used to locate frequencies with signals present. Basic scanning
operations are as follows.
• To scan
22
Press the
frequencies on the top and bottom
lines will switch places, with the
letters changing between capital
and lower case.
Press the
VFO
the
A=B
the display.
This will copy the frequency on the
currently used band (displayed on top line next to capital
letter) into the other band (displayed on bottom line next to
small case letter).
Press the
start and will proceed in the set
frequency steps.
3
2
1
While scanning, an arrow icon is displayed next to the
6
5
4
9
frequency on currently used band (displayed on top line
8
7
0
next to capital letter). The arrow points to the left while
C L R
scanning towards the higher frequencies.
Note:
If CTCSS or A/B Squelch is selected, the scan may be delayed since it takes
some time to match the selected parameters.
VFO
A=B
key. The
F
key, and then press
key while
is shown on
A~B S
key. Scanning will
SCN
N
FM
B
8 .
a
1 4 5 . 3 4
N
FM
A
1 4 5 . 3 4
b
1 4 5 . 3 4
N
FM
A
1 4 5 . 3 4
b
1 4 5 . 3 4