Internal Buzzer (Sp1); Speaker (Jd1); System Backup Battery (Bt1) - Supermicro Supero C7Z97-M User Manual

Internal Buzzer (SP1)

The Internal Buzzer (SP1) can be used
to provide audible indications for various
beep codes. See the table on the right
for pin definitions.

Speaker (JD1)

On the JD1 header, Pins 3~4 are used
for internal speaker. Close Pins 3~4 with
a cap to use the onboard speaker. If you
wish to use an external speaker, close
Pins 1~4 with a cable. See the table on
the right for pin definitions.

System Backup Battery (BT1)

A system backup battery is provided on
the motherboard. This provides backup
power to the CMOS when the system is
off. This is so the motherboard does not
lose its setup configuration. See Chapter
3 for instructions on how to replace the
battery.
JL2
JI2C1
JI2C2
JBT1
S8
S11
JF1
JSD1
I-SATA0
HD AUDIO
FAN5
C
BIOS
LICENSE
B
USB8/9(3.0)
JD1
A
I-SATA1
I-SATA3
FAN3
2-23
Internal Buzzer
Pin#
Pin 1 Pos. (+)
Pin 2 Neg. (-)
Speaker Connector
Pin Setting
Pins 3~4
Pins1~4
A. Internal Buzzer
B. Speaker Header
C. Backup Battery
HDMI/DP
LAN
USB 12/13
(3.0)
USB 2/3
(3.0)
JPL1
C7Z97-M
Rev. 1.00
JPW1
I-SATA1 I-SATA3 I-SATA5
I-SATA0 I-SATA2 I-SATA4
Chapter 2: Installation
Pin Definition
Definitions
Beep In
Alarm
Speaker
Pin Definitions
Definition
Internal Speaker
External Speaker
USB 0/1
VGA(IPMI)
KB/MOUSE
JPW2
S4
DIMMA1
DIMMA2
DIMMB1
DIMMB2
FAN2